Tactile Switch Module

Tactile Pushbutton Switch Module

This Momentary Tactile Push Button Module DC 5V Switch is ideally suited to add a button to your projects and gives a high signal when it is pressed. The module of the push button is a fully-fledged device with which you can install it immediately in the project, without using a pull-up or tightening resistances, because this is already in the circuit. The button together with the resistor is located on the board, where there are holes for installation. The built-in resistor has a rating of 10 k?.

Features/Specs:

- Operating Voltage: 3.3~5V

- Contact Resistance: ?50 M? max

- Electrically Life:100,000 cycles

- Environment temperature: -25’C+105’C

- Operating Force: 180/230(±20gf)

- Seal temperature: 250ºC-280ºC

- I/O pins: 3 pins

- PCB thickness: 1.5 mm

- Length: 20 mm

- Width: 16 mm

- Height: 7 mm